01.30 09:00

Master the Five Key Techniques for Loading Trucks with Loaders


Tip 1: For loaders, position the truck in the optimal loading spot before starting to load. For ordinary materials: Before loading with a loader, pay close attention to positioning the dump truck in the best location within the work area—this not only saves time but also boosts efficiency. Tip 2: Load with a plan. Before loading, think carefully about the loading sequence and try to keep the bucket as close to the front of the truck as possible. This way, when you’re nearing the top of the load, you won’t end up with half a shovel missing from the front. Always load with a well-thought-out plan. Tip 3: When the material is nearly full, push down any excess material. As the dump truck nears full capacity, gently push the material toward the side that has less material. In reality, the loading...


Tip 1: For loader loading, back the vehicle to the optimal loading position.
 
General materials: Before loading the loader, be sure to observe and position the dump truck in the optimal location within the work area—this will both save time and improve efficiency.
 
Tip 2: The loader is loaded according to a plan.
 
Before loading, the loader should first determine the loading sequence and try to position the bucket as close as possible to the front of the truck. This way, when the truck is nearly full, you won't end up with half a shovel missing from the front. The loader must follow a well-planned approach during the loading process.
 
Tip 3: When the material is nearly full, push down any excess to level it off.
 
When the dump truck is nearly full, you can gently push the material over to one side, trying to keep it concentrated on the less-full side. This is because, during actual loading, the loader may not be able to lift as high as needed. If there’s still just one shovel’s worth of material left to load at the back end, it’ll be very inconvenient if you fill the front too full all at once—especially when you’re about to seal the top.
 
Tip 4: When loading a loader onto a vehicle, the key is to master the time difference.
 
When loading materials, keep your right hand active and nimble. If the vehicle encounters significant resistance and can no longer move, make frequent adjustments to the boom and arm controls—don't just slam on the accelerator as soon as you feel resistance. Doing so not only wastes fuel and damages the machine but also fails to improve work efficiency.
 
Tip 5: During the loading process, pay attention to performing combined movements with the loader.
 
Shoveling in: Perform the actions of walking forward (with a forward lunge), extending the boom, and leveling the bucket simultaneously. As you approach the material pile, your bucket should just happen to be in the right position—take advantage of the momentum to shovel in smoothly. At the same time, reverse gear, raise the boom, and reverse the machine; as you reverse, slowly raise the boom while aligning the bucket. Once you’ve straightened the machine and shifted into forward gear, continue moving forward while gradually raising the boom. Unloading: Begin tipping the bucket to unload when you’re still some distance from the truck bed. Don’t worry about the material spilling out—because if your movements are quick enough, the material will lag slightly due to inertia before it starts to slide down. It won’t immediately spill out. When the bucket reaches the edge of the truck bed, keep tipping the bucket while lowering the boom slightly. Once the bucket is properly aligned with the truck bed, stop lowering the boom and briefly apply the brake. The material will then quickly slide out due to its own inertia. In short, don’t pause for even a second!
Related

Relevant Information